12) Click back to the main function table, click D delete, O only a certain pixel, L line, delete the lower half and bottom edge of the two vertical sides of the rectangle, as shown in Figure 6;
Image 6
13) Click back to the main menu, click C drawing, F round, R radius value, enter "5", round the upper left corner of the rectangle, as shown in Figure 7, enter "3", put the rectangle The top right corner is rounded, as shown in Figure 8;
Figure 7 Figure 8
14) Click Z:60.000 in the sub-function area and enter the Z-axis depth "23";
15) repeat steps 10) to 13);
16) Click Z:23.000 in the sub-function area and enter the Z-axis depth "-23";
17) repeat steps 10) to 13);
18) Click Z:-23.000 in the sub-function area and enter the Z-axis depth "-60";
19) repeat steps 10) to 13);
20) Click in the toolbar 
, set the angle of view to an isometric view, the result is shown in Figure 9;
Figure 9
21) Click in the toolbar 
with 
, both the viewing angle and the composition surface are set to the side view;
22) Click Z:-60.000 in the sub-function area and enter the Z-axis depth "60";
23) repeat steps 10) to 13);
24) Click Z:60.000 in the sub-function area and enter the Z-axis depth "23";
25) repeat steps 10) to 13);
26) Click Z:23.000 in the sub-function area and enter the Z-axis depth "-23";
27) repeat steps 10) to 13);
28) Click Z:-23.000 in the sub-function area and enter the Z-axis depth "-60";
29) repeat steps 10) to 13);
30) Click in the toolbar 
, the angle of view is set to an isometric view, the result is shown in Figure 10;
Previous page next page
Single Curtain Rods,Curtain Rods,Single Curtain Rods for Window
Botai Window Decoration Material Co., Ltd. , http://www.wlcurtainrod.com