Inspection of oil and inspection of replacement oil:
Check the oil and oil level before daily operation
1. When checking the oil, stop it and place it on the horizontal plane.
2. Loosen the oil scale and wipe clean.
3. Insert the dipstick into the filler port, but do not tighten it to see if the oil level is between the upper and lower scales. If the amount of oil is too small, you should add the required oil.
4. Replace and tighten the oil dipstick.
Oil change:
For best results, your small engine should be changed after 25 hours of first use or after the first month of initial use, and then replaced every 50 hours or every three months.
1. Warm up the engine for 2-3 minutes and turn off the engine. WARNING: Make sure the spark plug wire is disconnected and keep it away from the spark plug to prevent accidental starting. Clean the oil filling port and drain plug to prevent dirt and debris from falling into the crankcase
2. Put an oil box under the engine
3, loosen and remove the drain bolt, release the oil
4, using a hand to move the starter several times to help discharge all residual oil
5.Recommend and tighten the oil drainer oil recommendation:
In order to achieve the desired performance of the engine, it is recommended to use a certified Lonson engine oil. It is recommended to use SAE 10W-30 engine oil. When your area temperature is within the range shown in the diagram, other viscous motor oils can be used.
Spark Plug Inspection and Replacement Please replace the spark plug every 100 hours or every 6 months. The replacement of the spark plug has the following advantages:
Guarantee continuous spark start more reliable and save fuel
1, remove the spark plug cap, remove the surrounding debris
2. Remove spark plug with spark plug socket wrench
3, remove iron from the spark plug with iron braze, remove the spark plug debris with a brush
4, check the spark plug electrode ablation, if ablation, should replace the spark plug
5, check the spark plug gap with a thick gauge, adjust the spark plug gap to 0.7-0.8mm
6, check the spark plug seal, if it is seriously deformed or broken, should be replaced
7, spark inspection: hand start the engine, check the spark color, the spark should be blue and white
8. When the spark plug is tightened, in order to prevent the thread from being damaged, the spark plug should be screwed into place by hand, and then tightened with the spark plug sleeve.
Battery maintenance Note: Do not reverse the positive and negative batteries, otherwise it will cause a short-circuit circuit burning, serious damage to the battery and the engine.
The use of a new battery 1, a new battery plus electrolyte, the grid level on the grid to the upper scale 2, place 30 minutes after the charge for 30-60 minutes 3, install the first install + pole (red), and then install - pole (green ), and apply butter on the terminals.
Maintenance of the battery 1. Each time the electric start can not exceed 5 seconds, the start and ignition system should be checked after 3 consecutive starts.
2. Check the battery level every month. If it is lower than the scale mark, add distilled water.
3. If you do not use it for a long time, you should remove the battery and place it in a ventilated and dry place. Charge it once a month.
Check the oil and oil level before daily operation
1. When checking the oil, stop it and place it on the horizontal plane.
2. Loosen the oil scale and wipe clean.
3. Insert the dipstick into the filler port, but do not tighten it to see if the oil level is between the upper and lower scales. If the amount of oil is too small, you should add the required oil.
4. Replace and tighten the oil dipstick.
Oil change:
For best results, your small engine should be changed after 25 hours of first use or after the first month of initial use, and then replaced every 50 hours or every three months.
1. Warm up the engine for 2-3 minutes and turn off the engine. WARNING: Make sure the spark plug wire is disconnected and keep it away from the spark plug to prevent accidental starting. Clean the oil filling port and drain plug to prevent dirt and debris from falling into the crankcase
2. Put an oil box under the engine
3, loosen and remove the drain bolt, release the oil
4, using a hand to move the starter several times to help discharge all residual oil
5.Recommend and tighten the oil drainer oil recommendation:
In order to achieve the desired performance of the engine, it is recommended to use a certified Lonson engine oil. It is recommended to use SAE 10W-30 engine oil. When your area temperature is within the range shown in the diagram, other viscous motor oils can be used.
Spark Plug Inspection and Replacement Please replace the spark plug every 100 hours or every 6 months. The replacement of the spark plug has the following advantages:
Guarantee continuous spark start more reliable and save fuel
1, remove the spark plug cap, remove the surrounding debris
2. Remove spark plug with spark plug socket wrench
3, remove iron from the spark plug with iron braze, remove the spark plug debris with a brush
4, check the spark plug electrode ablation, if ablation, should replace the spark plug
5, check the spark plug gap with a thick gauge, adjust the spark plug gap to 0.7-0.8mm
6, check the spark plug seal, if it is seriously deformed or broken, should be replaced
7, spark inspection: hand start the engine, check the spark color, the spark should be blue and white
8. When the spark plug is tightened, in order to prevent the thread from being damaged, the spark plug should be screwed into place by hand, and then tightened with the spark plug sleeve.
Battery maintenance Note: Do not reverse the positive and negative batteries, otherwise it will cause a short-circuit circuit burning, serious damage to the battery and the engine.
The use of a new battery 1, a new battery plus electrolyte, the grid level on the grid to the upper scale 2, place 30 minutes after the charge for 30-60 minutes 3, install the first install + pole (red), and then install - pole (green ), and apply butter on the terminals.
Maintenance of the battery 1. Each time the electric start can not exceed 5 seconds, the start and ignition system should be checked after 3 consecutive starts.
2. Check the battery level every month. If it is lower than the scale mark, add distilled water.
3. If you do not use it for a long time, you should remove the battery and place it in a ventilated and dry place. Charge it once a month.
80-120Mm Calcium Carbide,Inorganic Salts Classification Calcium Carbide,Cac2 Calcium Carbide,Calcium Carbonate Powder
shizuishan pengsheng chemical co.,ltd , http://www.szspschem.com