Renovation may be a headache for most people because you have to buy materials and also have to manage the renovation process to prevent decoration workers from cutting corners during renovations. And often due to some things in the decoration did not notice, and bring a lot of trouble. Especially in the decoration of second-hand housing better pay attention, because if it is not a good decoration caused by the life of the original housing compared to the new house said that the short-term second-hand housing life, further reduced, it would be even more painful, so in the second-hand housing renovation second Aspects must be remembered:
Nippon Paint      Super floor
First, the roof.
Generally living for a few years of second-hand housing decoration decoration renovation is mostly cement prefabricated floor, this type of housing for many years after the cement prefabricated floor will have different degrees of cracking powder plastic drum fallope drum mold discoloration, which requires Decoration company before the start of a comprehensive inspection, the right medicine, medicine to get rid of: cracking the floor of the solution is to knock the original powder layer, playing iron nails to strengthen the cracks, cement paste and then paste a good cloth, putty paint.
Second, the wall.
Second-hand house decoration decoration decoration renovation wall First use a special tool to fully check all the walls again: flatness, level, positive corner angle and so on, the substrate is all must be cleared to the masonry and then clean, repainting Two degrees of cement mortar, then grant putty paint. If the substrate is a cement mortar, it is important to check whether the powder layer has cracks in the empty drum wall. Then the right medicine: empty wall, you must knock down the powder layer see the masonry, clean, repaint the cement mortar; good old wall surface is yellow, especially when cooking smoke, smoke, gas fumigation Through the wall, there are two options: First, to completely remove the original old putty wall; Second, all the walls are painted with a layer of media closed. If you do not use that method, you must remove the wall iron and wood pile nails in advance, and clean the pile holes, and then cement and repair the formation of the next process.
Third, the ground.
If it is the ground floor, there is no empty floor below. It is recommended that whether it is to make the floor warm, put on the floor tiles or the floor, the ground should be waterproof and damp-proof, and the wall surface should be more than 30cm above the ground.
Fourth, second-hand housing decoration decoration decoration waterway, circuit is the most critical work.
Most of the used old houses are used for many years. Due to factors such as the economic design of many years ago, the aging of water pipes and wires is not standardized. Therefore, the layout of space and space should be renewed. Some of the issues that should be noted here are:
1 In the process of laying cables, pay attention to the direction of the original pipelines such as gas, circuit water, and weak currents, and do not influence them.
2 carefully examine the structure of the joint masonry with the neighbors during the process of drilling the pipeline slots shall not affect the neighbors;
3 During the process of grooving, dust and noise will be generated. In addition to close the doors and windows for dust removal, it is necessary to fully liaise with neighbors before construction so as not to affect the neighbor’s learning work and obtain understanding from neighbors, so as to reduce decoration trouble and ensure smooth decoration. get on.
Fifth, woodworking engineering.
Because the structure of the second-hand old houses is not very reasonable, there are a lot of sites for renovating new powders. All the wooden substrates must be painted and moisture-proof, and the walls of new new powders are not yet completely dry and stable. Be careful when drilling the fixing member.
Sixth, second-hand housing decoration decoration renovation paint work is also very important.
Paint is the last pass. Why do you say so? The pre-laying results were fully tested. The painter had to paint all the fine hair gaps of the interface agent thoroughly on all the tops of the wall at this time. It was the truest view, and some were the normal gaps formed by the shrinkage of the cement mortar. It may be the structural cracks caused by the shrinkage of the foundation wall. At this time, it was found that all the white fabrics must be sticky and sticky in time to be able to be used once and for all.
Seventh, hydropower installation
Second-hand housing decoration decoration decoration paint finish is the end of the installation of hydropower equipment, and at this time can best test the construction quality of the various types of work. The unimpeded flow of floor drains is the right choice for all types of work during the construction process; the smooth flow of circuit waterways is the result of the construction specifications of various types of civilizations; the holes in the reserved equipment components on the wooden work wall tiles conform to the specifications. Standardize the embodiment of civilized construction.
Second-hand house decoration construction acceptance entrance decoration cement paint decoration house paint decoration find decoration company please floor tile
Here are all MAKITA power tools and the designated carbon brushes,motor brushes, electric brushes, motor brushes, electric motor brushes or simply brushes.
For each power tool, there are usually two carbon brushes to choose from: With automatic stop and without automatic stop. Carbon brushes with automatic stop have a spring through the length of the carbon brush. When the carbon brush wears out, the spring gets released, the current to the carbon brush gets interrupted and your power tools switches off at once. The advantage: No additional wear and tear to your power tool. Carbon brushes without automatic stop do not stop functioning at once, but performance of your power tool will detoriate rapidly. Although handy as a warning sign, this usually isn't very beneficial to your power tool.
If you can't find your MAKITA power tool here, please contact us: Most likely we can help!
Makita Carbon Brush Motor,Makita Carbon Brush,Carbon Brush For Makita Tools,Power Tool Makita Carbon Brush,Makita Parts Carbon Brush
Haimen Hailing Carbon Industry Co., Ltd. , http://www.carbonbrush-hl.com